Feb 21, 2025 Leave a message

How do you make ferro silicon?

1. Preparation of raw materials

 

The first step in the production of ferrosilicon is to prepare the raw materials, which are mainly silica, coke, scrap steel and so on. Different materials have different roles.

  • Silica: its main source is quartz sand.
  • Iron source: the main source of iron is scrap steel or iron ore.
  • Reducing agent: the most commonly used reducing agent in our production is coke or charcoal.
  • Other additives: other additives are also added according to the actual application, such as limestone, which is used to adjust the slag composition.

 

2. Batching

 

After the raw materials are prepared, workers need to mix silica, iron source, reductant and additives according to the proportion to ensure that the chemical reaction in the furnace goes on smoothly. The key to this step is to ensure that the proportion of the various raw materials is accurate.

 

3. Furnace loading

 

Workers load the mixed raw materials into the electric arc furnace or mineral heat furnace.

 

4. Smelting

 

  • Heating: Temperature control during smelting is very important, too high or too low temperature will affect the quality of ferro silicon. The temperature is usually heated to 1600-1800°C by electricity to melt the raw materials.
  • Reduction reaction: When the temperature is heated to a high temperature, the coke reduces the silicon out of the silica to produce a ferrosilicon alloy.

 

5. Iron out

 

After the melting is completed, open the iron outlet at the bottom of the furnace and pour the liquid ferro silicon into the iron ladle.

 

6. Pouring

 

After refining, the liquid ferro silicon is cast and cooled. During the casting process, the liquid ferro silicon is poured into moulds to form solid ferro silicon ingots.

 

7. Crushing and Packing

 

Workers crush the ferro silicon ingots into required sizes according to the order and pack them for storage or transport.

 

8. Quality Control

 

The finished production is subject to quality control, and the finished products are tested for chemical composition and physical properties to ensure that the ferro silicon meets the relevant standards and customer requirements.

 

Precautions

 

  • Safety protection: Since the operating environment is at a high temperature, workers should wear protective equipment during production.
  • Environmental protection measures: waste gas and waste residue will be produced during production, so these wastes should be handled reasonably to avoid polluting the environment.
  • Scrapping of defective products: After the quality inspection, workers have to re-process or scrap the unqualified products, and the defective products can't be sold normally.

 

Send Inquiry

whatsapp

Phone

E-mail

Inquiry